ABB SM1000 User Manual page 75

Videographic Recorder
SM1000
100
Sample Interval
Maximum Value over sample interval
Instantaneous Value at time of sample
Average Value over sample interval
Raw
Input
Value
Minimum Value over sample interval
0
12:00:01
12:00:00
(Current
(Previous
Sample)
Sample)
•1 If this parameter is changed, internally recorded data files are recreated and unarchived data is lost.
IM/SM1000 Issue 11
t
Each recording channel can be configured to position its trace in
a specific zone in the chart views in order to separate traces that
would otherwise be very close to each other.
Note. The trace colors cannot be changed. The trace colors
are:
1st 2nd
Magenta Red
Select one of the 15 pre-defined zones available.
Select the filter to be applied to the electrical input prior to
•1
sampling.
Note.
Applicable to analog sources only.
Filters are applied to the recorded values shown on the
chart view only, not to instantaneous values displayed on
the channel indicators or bargraphs.
Instantaneous – A single value based on process conditions
at the time of sampling.
Average – The average value of the analog signal since
the previous sample.
Minimum – The minimum value of the analog signal
since the previous sample.
Maximum – The maximum value of the analog signal
since the previous sample.
Max & min – Two values are recorded to capture the
maximum & minimum signal values since the
previous sample. This allows the memory
use to be extended by permitting a slower
sample rate to be selected without losing the
transient behavior of the signal.
4 Configuration
3rd 4th 5th
Black Green Blue
6th
Brown
73