Qinq Transparent-Vlan - HP 3600 v2 Series Command Reference Manual

Parameters
hex-value: Hexadecimal TPID value, ranging from 0x0001 to 0xFFFF. However, do not set it to any of the
protocol type values listed in
Description
Use qinq ethernet-type service-tag to configure the TPID value in SVLAN tags.
Use undo qinq ethernet-type service-tag to restore the TPID value in SVLAN tags to the default setting.
By default, the TPID value in SVLAN tags is 0x8100.
On a port with basic QinQ and customer-side QinQ not enabled, the switch judges whether a frame is
VLAN tagged based on the SVLAN TPID value on the port.
Configured in Ethernet interface view, this command takes effect on the current port only. Configured in
port group view, this command takes effect on all ports in the port group. Configured in Layer 2
aggregate interface view, this command takes effect on the Layer 2 aggregate interface and the member
ports in its aggregation group.
Examples
# Set the TPID value in the SVLAN tags to 0x9100 on Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] qinq ethernet-type service-tag 9100

qinq transparent-vlan

Syntax
qinq transparent-vlan vlan-list
undo qinq transparent-vlan { all | vlan-list }
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default level
2: System level
Parameters
vlan-list: Specifies a list of existing VLANs in the format of vlan-list = { vlan-id1 [ to vlan-id2 ] }&<1- 1 0>,
where vlan-id1 and vlan-id2 represent the VLAN IDs and each range from 1 to 4094, vlan-id2 cannot be
smaller than vlan-id1, and &<1- 1 0> indicates that you can specify up to 10 vlan-id1 [ to vlan-id2 ]
parameters.
all: Indicates all VLANs.
Description
Use qinq transparent-vlan to configure VLAN transparent transmission on one or multiple ports, so the
port or ports can transparently transmit frames from the specified VLANs.
Use undo qinq transparent-vlan to remove the configuration.
By default, VLAN transparent transmission is not configured on ports.
Configured in Layer 2 Ethernet interface view, the command takes effect on the interface only.
Configured in Layer 2 aggregate interface view, the command takes effect on the Layer 2 aggregate
Table 48.
228