Port Hybrid Ip-Subnet-Vlan - HP 3600 v2 Series Command Reference Manual

the source IP address or network address, in dotted decimal notation with a default value of
255.255.255.0.
to: Specifies an IP subnet index range.
ip-subnet-end: Specifies an end IP subnet index, in the range of 0 to 1 1. The value must be greater than
or equal to the beginning IP subnet index.
all: Removes all the associations between VLANs and IP subnets or IP addresses.
Description
Use ip-subnet-vlan to associate the VLAN with a specified IP subnet or IP address.
Use undo ip-subnet-vlan to remove the association.
The IP subnet or IP address cannot be a multicast network segment or a multicast address.
Related commands: display ip-subnet-vlan vlan.
Examples
# Configure VLAN 3 as an IP subnet-based VLAN and associate it with the 192.168.1.0/24 network
segment.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] ip-subnet-vlan ip 192.168.1.0 255.255.255.0

port hybrid ip-subnet-vlan

Syntax
port hybrid ip-subnet-vlan vlan vlan-id
undo port hybrid ip-subnet-vlan { vlan vlan-id | all }
View
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN ID, in the range of 1 to 4094.
all: Specifies all VLANs.
Description
Use port hybrid ip-subnet-vlan to associate the Ethernet port with the specified IP subnet-based VLAN.
Use undo port hybrid ip-subnet-vlan to remove the association.
On an Ethernet port associated with an IP subnet-based VLAN, if the source IP address of a received
untagged packet belongs to the corresponding IP subnet, the port tags the packet with the corresponding
VLAN tag.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
The configuration made in port group view applies to all ports in the port group.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
189