HP 3600 v2 Series Command Reference Manual page 16

Field
promiscuous mode not set
Output queue (Urgent queue:
Size/Length/Discards)
Output queue (Protocol queue:
Size/Length/Discards)
Output queue (FIFO queuing:
Size/Length/Discards)
Last clearing of counters
Last 300 seconds input
Last 300 seconds output
Input
Output
# Display detailed information about Layer 2 interface Ethernet 1/0/1.
<Sysname>display interface ethernet 1/0/1
Ethernet1/0/1 current state: DOWN
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e2aa-0825
Description: Ethernet1/0/1 Interface
Loopback is not set
Media type is twisted pair
Port hardware type is
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 10000
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Port priority: 0
Last clearing of counters:
Peak value of input: 0 bytes/sec, at 2010-01-01 02:08:56
Peak value of output: 0 bytes/sec, at 2010-01-01 02:08:56
Last 300 seconds input:
Last 300 seconds output:
Description
The interface operates in non-promiscuous mode.
Output queue (current message number in the urgent queue, maximum
number of messages allowed in the urgent queue, and number of discarded
messages).
Output queue (current message number in the protocol queue, maximum
number of messages allowed in the protocol queue, and number of
discarded messages).
Output queue (current message number in the FIFO queue, maximum
number of messages allowed in the FIFO queue, and number of discarded
messages).
Time when the reset counters interface command was last used to clear the
interface statistics. Never indicates the reset counters interface command
was never used on the interface since the switch was started.
Average input rate over the last 300 seconds in Bps, bps, and pps.
Average output rate over the last 300 seconds in Bps, bps, and pps.
Input packets.
Output packets.
100_BASE_TX
Never
0 packets/sec 0 bytes/sec -%
0 packets/sec 0 bytes/sec -%
8