Setting For The Programming Tool - Mitsubishi Electric Q03UDVCPU User Manual

3.2

Setting for the Programming Tool

Configure the settings in the "Transfer Setup" window.
Connection Destination window
2.
3.
1.
Select "Ethernet Board" for "PC side I/F".
In the "PC side IF Ethernet Board Setting" window, select a "TCP" or "UDP" protocol. Select the same
protocol as the one set in the Ethernet Configuration or the Open Setting window. (
3.1)
CHAPTER 3 CONNECTION OF PROGRAMMING TOOLS AND GOT
[Connection1]
1.
Page 25, Section
27
3