Removing The Hard Drive From The Hard Drive Carrier - Dell EMC PowerEdge R940 Installation And Service Manual

Steps
1 Press the release button on the front of the hard drive to open the release handle.
2 Insert the hard drive into the hard drive slot and slide until the hard drive connects with the backplane.
3 Close the hard drive release handle to lock the hard drive in place.
Figure 36. Installing a hard drive
Next steps
If applicable, install the front bezel.
Related links
Installing the optional front bezel

Removing the hard drive from the hard drive carrier

Prerequisites
Follow the safety guidelines listed in
CAUTION: Mixing hard drives from previous generations of PowerEdge servers is not supported.
Steps
1 Using Phillips #1 screwdriver, remove the screws from the slide rails on the hard drive carrier.
2 Lift the hard drive out of the hard drive carrier.
Safety instructions.
Installing and removing system components 83