Installing The Right Control Panel - Dell EMC PowerEdge R940 Installation And Service Manual

Related links
Removing the fan cage
Removing the fan tray
Removing the air shroud
Removing the expansion card riser
Removing the PEM

Installing the right control panel

Installing the right control panel
Prerequisites
Follow the safety guidelines listed in
Steps
1 Route the cables through the cable routing hooks on the side of the system.
2 Lower the cable management bracket into the system.
3 Press the bracket and insert the tabs on the bracket into the slots on the right side of the system.
4 Align the control panel with the control panel slot on the system and attach the control panel to the system.
5 Connect the control panel cable connector on the system board.
6 Using Phillips #1 screwdriver, install the screws that secure the control panel to the system.
Figure 96. Installing the right control panel
148 Installing and removing system components
Safety instructions.