Installing The Pem Power Board - Dell EMC PowerEdge R940 Installation And Service Manual

Figure 68. Removing the PEM power board
Next steps
If applicable, install the PEM power board.
Related links
Removing the air shroud

Installing the PEM power board

Installing the PEM power board
Prerequisites
1 Follow the safety guidelines listed in
Steps
1 Hold the PEM power board by its edges, position the power board so that the power board connector aligns with the connector on
the system board.
2 Insert the power board into the connector on the system board until the power board is fully seated.
114 Installing and removing system components
Safety instructions.