Preparing The Water Connection (A); Installing The 90° Elbow Fitting (B); Junction Box Preparation (C) - Blomberg DW 14110 NBL00 Service Manual

5.11.

Preparing The Water Connection (A)

Install an easily accessible shut-off valve (not supplied) in the water supply line. All solder
connections must be made before the water line is connected to the dishwasher's water inlet
valve. Water can also be supplied to the dishwasher by using a flexible braided hose line.
Check with your plumbing supply sources for the proper hose and 90° elbow and necessary
fittings for the water supply line. This material is not supplied, and must be purchased separately.
Installation should be performed by a qualified installer. Work by
unqualified persons could be dangerous and may void the warranty.
If the dishwasher is installed in a location that experiences freezing temperatures (e.g. in a
vacation home, cabin etc.), you must drain all the water from the dishwasher's interior. Water
system ruptures that occur as a result of freezing are not covered by warranty.
5.11.1. Installing The 90° Elbow Fitting (B)
5.11.2.

Junction Box Preparation (C)

BUILT- UNDER DISHWASHER
Do not over tighten the 90°
elbow.
damage the water inlet valve and cause a
water leak.
If the water supply line is to be copper tubing,
make certain that the elbow has a compression
fitting. Apply Teflon tape or other pipe sealant
when required.
connection downwards as shown in the figure so
the water line can be easily pulled underneath or
on the side of the dishwasher.
Remove the junction box cover by removing the
screws as shown in the figure. They will be
reinstalled later.
23
Doing so
Orient the water
2011
may
supply