Fasten Junction Box - Blomberg DW 14110 NBL00 Service Manual

5.16.2.

Fasten Junction Box

Install a strain relief (not supplied) into the opening on the kick
plate. (Figure A)
Pass the electrical supply cable through the strain relief; make
sure the strain relief clamps the insulated outer casing of your
electrical supply cord and not the wires themselves. Leave
215/16" " to 315/16" " (75mm / 100mm) of insulated wire
extending through the strain relief (Figure B). Tighten the strain
relief screws. (Make sure you can not pull the electrical cord out)
of the strain relief.
Do not pre-twist the wires before connecting them with wire
nuts.
Using the supplied wire nuts, connect the electrical supply wires
to the dishwasher's wires, black to black, white to white, and
green or bare to green or bare. Make certain that the insulated
wires show no bare wire from the bottoms of the wire nuts.
Gently tug the wires to make certain they are securely
connected (Figure C).
1. Pull the wires into the junction box. Be sure that the wire
nuts do not loosen.
2. Replace the cover on the junction box.
3. Secure the cover with the screws (Figure D).
28
BUILT- UNDER DISHWASHER
2011