Preparing The Water Connection (A); Installing The 90° Elbow Fitting (B); Junction Box Preparation (C) - Blomberg DWT 14210NBL00 Installation Manual

B

6.5 PREPARING THE WATER CONNECTION (A)

Install an easily accessible shut-off valve (not supplied) in
the water supply line. All solder connections must be made
before the water line is connected to the dishwasher’s water
inlet valve. Water can also be supplied to the dishwasher
by using a flexible braided hose line.
Check with your plumbing supply sources for the proper
hose and 90° elbow and necessary fittings for the water
supply line. This material is not supplied, and must be
purchased separately.
WARNING
Installation should be performed by a qualified installer.
Work by unqualified persons could be dangerous and
may void the warranty.
If the dishwasher is installed in a location that
experiences freezing temperatures (e.g. in a vacation
home, cabin etc.), you must drain all the water from the
dishwasher's interior. Water system ruptures that occur
as a result of freezing are not covered by warranty.
6.5.1 INSTALLING THE 90° ELBOW FITTING (B)
CAUTION
Do not over tighten the 90° elbow. Doing so may damage
the water inlet valve and cause a water leak.
If the water supply line is to be copper tubing, make certain
that the elbow has a compression fitting. Apply Teflon tape
or other pipe sealant when required. Orient the water supply
connection on the left side as shown in the figure so the
A
water line can be easily pulled underneath or on the side of
the dishwasher.

6.5.2 JUNCTION BOX PREPARATION (C)

Remove the junction box cover by removing the screw as
shown in the figure. They will be reinstalled later.
C
8