Overview Of Parameters On The Configuration Level - ABB PositionMaster EDP300 Operating Instruction

Change from two to one column
8.3

Overview of parameters on the configuration level

IMPORTANT (NOTE)
This overview of parameters shows all the menus and parameters available on the device. Depending on the
version and configuration of the device, not all of the menus and parameters may be visible on it.
Easy Setup 1
Device Setup 2
Display 3
Control 4
Input/Output 5
Actuator Type
Vent Position %
Shut-Off 0%
Control at 0%
Shut-Off 100%
Control at 100%
Auto Adjust Mode
Start Auto Adjust
Actuator Type
Vent Position
SETPOINT
RANGE SETTINGS
END STOP BEHAVE.
Recalc. Position
ENGINEERING UNITS
Display Value
Contrast
Zone
Dead Band
DB Approach
DB Timeout
KP Up
KP Down
TV Up
TV Down
Y-Offset Up
Y-Offset Down
DIGITAL INPUT
ALARM OUTPUT
DI Function
DI Default SP
DI Logic
ALARM LOGIC
DO ALARM MASK
Alarm Simulation Alarm Maintenan.
Alarm OoSpec.
Alarm Check Fct.
Alarm Failure
PositionMaster EDP300 | OI/EDP300-EN 29