Electrical Connections; Connection Diagram - ABB PositionMaster EDP300 Operating Instruction

Change from two to one column
5

Electrical connections

1. Strip the wire by approx. 6 mm (0.24 inch).
2. To connect the signal lines, the emergency shutdown module, and the proximity switches or microswitches, insert the wire
ends from the left into the respective screw terminals and tighten the screws so that they are hand-tight (access from
above). To connect a plug-in module, insert the wire ends from above into the appropriate screw terminals and tighten the
screws so that they are hand-tight (access from the side).
5.1

Connection diagram

A
1 2
+11 -12 +81-82 +83 -84
AI DI
Fig. 17: Terminal connection diagram
A Basic device | B Options
1 Analog input | 2 Digital input | 3 Digital output | 4 Digital feedback | 5 Analog feedback | 6 Proximity switches |
7 Microswitch | 8 Emergency shutdown module | 9 Universal input
IMPORTANT (NOTE)
Keep cable shields as short as possible and
connect on both sides.
16 OI/EDP300-EN | PositionMaster EDP300
3 4
+51 -52 +41 -42
DO SW 2 SW 1
B
5 6
+31 -32 +51 -52 +41 -42
AO Limit 1 Limit 2
7 8
41 42 43 51 52 53 +85 -86
Limit 1 Limit 2
9
+21 -22
UAI
M10239