Mitsubishi Electric GOT2000 Series Connection Manual page 70

(2) HITACHI HIDIC H (Protocol2)
Item Description
Set this item when change the
transmission speed used for
Transmission
communication with the connected
Speed
equipment.
(Default: 19200bps)
Set this item when change the data
length used for communication with
Data Bit
the connected equipment.
(Default: 7bit)
Specify the stop bit length for
Stop Bit communications.
(Default: 1bit)
Specify whether or not to perform a
parity check, and how it is performed
Parity
during communication.
(Default: Even)
Set the number of retries to be
performed when a communication
Retry
error occurs.
(Default: 0time)
Set the time period for a
Timeout Time communication to time out.
(Default: 3sec)
Set this item to adjust the
transmission timing of the
Delay Time communication request from the
GOT.
(Default: 0ms)
Specify whether to use the station No.
during communication.
Station No.
If [Yes] is selected, the station No. is
Selection
fixed to "0."
(Default: Yes)
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be
changed on the Utility's [Communication Settings]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
2 - 10
2. CONNECTION TO HITACHI IES PLC
2.4 GOT Side Settings
Range
4800bps,
9600bps,
19200bps,
38400bps
7bit (fixed)
1bit (fixed)
Even (fixed)
0 to 5times
1 to 30sec
0 to 300 (ms)
Yes or No