Panasonic KX-NS1000 Pc Programming Manual page 45

Note
•
Full Automatic and Extension Number Input registration methods may not be available for
certain types of IP terminals. In such cases, select the Manual registration method.
•
For more information about the IP terminal registration modes, refer to 5.9 Registering IP
Telephones in the Installation Manual.
b.
For One Look Networking (Trial Activation Key), specify whether to activate the 60-day One-look
Networking Trial Activation Key.
–
If Active is selected, the 60-day trial will begin when the Easy Setup Wizard is completed.
–
If Non Active is selected, you will have to activate the trial manually in order to use One-look
Networking Features on a trial basis.
c.
Click Next.
If Slave has been selected in step 1, the Easy Setup Wizard will finish at this step. If LAN settings have
been changed from their default values in step 3, you will be prompted to restart the PBX. Click OK to
restart the PBX.
To add the PBX as a Slave unit PBX to the One-look network, use the Add Site Wizard from the Master
unit PBX's Home Screen. See 3.1.1 Home Screen—Add Site Wizard.
5.
In SNTP / Daylight Saving, enter information for Automatic Time Adjustment and Daylight Saving, and
then click Next.
6.
In Maintenance Setting, the Installer password, information for SNMP Setting and SNMP Manager can
be entered.
a.
Enter a password for the Installer level account in Installer password. Confirm your input in
Re-enter.
b.
Specify settings for SNMP Setting and SNMP Manager if necessary. If you are unsure of your
network's SNMP settings, contact your network's administrator.
c.
Click Finish.
7.
Follow the prompts of the Easy Setup Wizard. After the Easy Setup Wizard is completed, if LAN settings
have been changed from their default values in step 3, you will be prompted to restart the PBX. Click OK
to restart the PBX. Otherwise, the login screen will be displayed.
8.
Log in with the Installer level account using the password entered during Easy Setup Wizard. The Home
Screen is displayed. You may now begin programming the PBX.
*1 Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2 Valid subnet mask address range: "0-255.0-255.0-255.0-255" (except "0.0.0.0" and "255.255.255.255")
Notice
•
The IP address of the PBX must not be changed once it is set. When an external DHCP server is used
to automatically assign IP addresses, it must be configured to always allocate the same IP address to
the PBX. For details, consult your network administrator.
•
If an external DHCP server is in use, it must be able to use a "client identifier" option specified by RFC
2131.
2.1.4 Easy Setup Wizard
PC Programming Manual 45