Panasonic KX-NS1000 Pc Programming Manual page 189

Value Range
Inband, Outband (RFC2833), Outband (H.245)
Maintenance Console Location
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property
Payload Type
Specifies the payload type for DTMF tones using RFC2833. Programming this parameter is only necessary if
DTMF is set to Outband (RFC2833).
Value Range
96–127
Maintenance Console Location
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property
Multisite message resend time
Specifies the re-sending time for message communication between the Master unit and Slave units.
Value Range
500–8000 ms, in units of 500 ms
Maintenance Console Location
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property
Multisite message resend expired time
Specifies the number of seconds after which a message being re-sent between the Master unit and Slave units
will timeout if it cannot be sent.
Value Range
150–240 s
Maintenance Console Location
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property
Multisite for PBX UDP port number
Specifies the first of two contiguous UDP ports to be used for Type 1 message communication between the
Master unit and Slave units.
Note
The UDP port specified here and the next contiguous port will be assigned for transmission.
Example: If the value set here is 4560, ports 4560 and 4561 will be assigned.
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property
PC Programming Manual 189