Installation Procedure - Hitachi IJ UX Service Manual

1.3.2 Installation procedure

Perform an installation work of the unit according to the following procedure at the
unpacking.
1 The cap of the compensating port is detach.
(Caution 1)
2 Service personnel maintenance mode setup
procedure
3 Selection of ink type(Touch screen
operation)
Fill ink and makeup in each reservoir.
4
5 Ink stream alignment
(For filling makeup path and adjusting ink stream
position)
Replenish the ink in the main ink tank.
6
And fill ink in the ink circulation routes.
(Replace solvent with ink)
Ink replenishment (second replenishment)
7
(Fill ink into a circulating system)
8 Ink replenishment (second replenishment)
(Fill ink into a circulating system)
Pressure adjustment
9
(Set pressure to the standard value of every ink)
Adjustment of excitation voltage
10
(Touch screen operation, automatic acquisition)
Supply port cap
Ink reservoir
Service Manual
2.1 Setting of service personnel
maintenance mode
Service Manual
2.2 System environment setup
Instruction manual
8. Ink and Makeup replenishment
<NOTE>If the makeup in the Cartridge
bottle is used as a cleaning solution,
pour the contents in the cleaning bottle
before the cartridge bottle is set.
Technical Manual
6.5 Stream alignment
Press Installation Ink refill on
< Circulation control >.screen.
<NOTE>Insert the tip of the Printhead
into the beaker at Ink refill.
Press Ink drainage on < Circulation
control >.screen. Follow the guidance
displayed on the screen to perform Ink
drainage.
Press Ink refill on < Circulation control
>.screen.
<NOTE>Insert the tip of the Printhead
into the beaker at Ink refill.
Technical Manual
6.9 Adjusting the pressure
Service Manual
2.3.1 Excitation adjustment
1-13
Supply port cap
Makeup reservoir