Hitachi IJ UX Service Manual page 135

4.1.2 Access to the parts on the front side of the equipment
1 Remove the Inner cover (T).
.
2 Remove the fixing screws(2) (2 pieces) and draw the reservoir unit out to the front
halfway by supporting "a" part (4 places) with both hands.
ａ
Fixing screw(2) Pull out Reservoir Unit
3 Remove the tubes and cables from the clamp.
Clamp
4 Pull the reservoir unit out further and put it on the maintenance cover.
Reservoir Unit
Reservoir Unit
Inner cover (B)
ａ
Tube/Cable
Maintenance cover
Clamp
[CAUTION]
Carefully mount the Reservoir unit back
to its place so that the piping tube of
the recovery filter is not pinched.
After performing the task of pulling the
Reservoir unit, please make sure that the
level sensor is functioning normally Street.
4-2
Rock pin guard
【CAUTION】
Please do not remove the
rock pin guard.
When you removed any
chance, please return to the
original.
Remove
Tube/Cable