UNIVERGE SV8100
System Hardware Manual
3.2.1
Connecting Cables to the AD(A)-R Unit
The first step in installing the AD(A)-R Unit is to connect the cables
between the recording device and the AD(A)-R Unit.
Cable terminal connectors are located on the side of the AD(A)-R
Unit. Cables should be connected on this unit before installing the
unit on the multiline terminal.
Cables can be connected to determine whether or not pause control
is provided for the recording.
Recording
Device
Mini-Plug
Earphone
Figure 9-8 AD(A)-R Unit Connection without Pause Control
Mini-Plug
Remote
Recording
Mini-Plug
Device
Line In
Figure 9-9 AD(A)-R Unit Connection with Pause Control
To connect the cables:
1.
Cut off the plug on one end of the cable.
2.
Remove the screw as illustrated in
AD(A)-R Unit Cover on page 9-8
Mini-Plug
Connection Cord
CN2
Mini-Plug
Connection Cord
T6 (Shielded Wire)
T7 (Wire)
Mini-Plug
Connection Cord
AD(A)-R Unit
AD(A)-R Unit
CN2
Figure 9-10 Removing
and open the unit cover.
Issue 9.0
9 - 7