Control Elements; Overview; Trip Bus - GE C30 Instruction Manual

CONTROL ELEMENTS

5
5.7 Control elements

5.7.1 Overview

Control elements are used for control rather than protection. See the Introduction to Elements section at the beginning of
this chapter for information.

5.7.2 Trip bus

SETTINGS  CONTROL ELEMENTS  TRIP BUS  TRIP BUS 1(6)
 TRIP BUS 1

5-146
Figure 5-68: Non-volatile latch operation table (N = 1 to 16) and logic
Latch n type Latch n
set
Reset ON
Dominant
OFF
ON
OFF
Set ON
Dominant
ON
OFF
OFF
TRIP BUS 1

FUNCTION: Disabled
TRIP BUS 1 BLOCK:

Off
TRIP BUS 1 PICKUP

DELAY: 0.00 s
TRIP BUS 1 RESET

DELAY: 0.00 s
TRIP BUS 1 INPUT 1:

Off
Latch n Latch n Latch n
reset on off
OFF ON OFF
OFF Previous Previous
State State
ON OFF ON
ON OFF ON
OFF ON OFF
ON ON OFF
OFF Previous Previous
State State
ON OFF ON
Range: Enabled, Disabled
Range: FlexLogic operand
Range: 0.00 to 600.00 s in steps of 0.01
Range: 0.00 to 600.00 s in steps of 0.01
Range: FlexLogic operand

C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS