Installation Instructions; Reversing The Door - Blomberg FNM1541I User Manual

3 Installation

Installation Instructions

1. To avoid a hazard due to instability
of the appliance, it must be fixed in
accordance with the instructions.
2. Do not operate this appliance unless
installed in furniture (The appliance
should be located on a smooth
surface).
3. Refer to "Cleaning and Care" section
to prepare your appliance for use.

Reversing The Door

We recommend that you reverse the
door before switching on for the first
time.
Tools required: Small and medium size
flat and cross-headed screwdrivers, a
pair of pliers.
Spare Parts supplied in the plastic
bag: The following parts, which are
exclusively for left hand side fitted hinge
operation are supplied in a plastic bag
with the appliance:
- Door top trim hinge covers – there
are 2 different parts, one for each side
of top trim.
We suggest you keep all the parts
supplied in the plastic bag and also
parts, which have been removed when
reversing the door, in a safe place for
possible future, re-use.
Important:
We suggest you ask somebody to
help you when moving the appliance
around and to hold the door when
removing / re-fitting hinges and the
door to avoid any injury and damage
to the product.
Please refer to diagrams supplied. To
follow numbers in brackets below,
refer to the main diagram.
1. Switch off the appliance at the
socket outlet and pull out the mains
plug.
2. Remove all loose items and
fittings and food inside the appliance.
3. Gently prise off plastic hinge
covers on both sides of front top panel
using a small flat-headed screwdriver.
(1-2)
4. Unscrew the bolts of the top
hinge and remove top hinge. (3)
5. Remove door carefully off the
bottom hinge and stand door upright
in a safe place.(4)
6. Gently prise off plastic hinge
cover on door top trim. Fit the other
door top trim plastic off hinge cover
supplied in the plastic bag.(5)
7. Gently tilt the appliance back
against a strong wall on its rear side
sufficiently to allow the lower hinge
to be removed. Take care to protect
the appliance, your wall and floor
coverings. You can utilise the original
packaging to do this.Once you tilt the
appliance back, check to make sure
the appliance is completely stable and
safe before you carry on. (6)
8. Unscrew and remove the front
feet and 1 bolt. (7)
9. Unscrew and remove the
bottom hinge. (8)
10. Unscrew and remove the
bottom hinge door stopper and
bushing and reposition them on the
other side while rotating the bushing
180°. (9)
11. Fit the bottom hinge and tighten
the screws as shown in figure. (10)
12. Fit the other front feet as shown
in figure. (11)
10
EN