Yamaha CL1 Reference Manual page 54

Using the faders (SENDS ON FADER mode)
You can use the faders on the top panel to adjust signals that are sent from the MIX and STEREO/
MONO channels to a specific MATRIX bus.
1.
Make sure that an output port is assigned to the MATRIX bus to which you want
to send signals, and that your monitor system etc. is connected to the
corresponding output port.
2.
In the function access area, press the SENDS ON FADER button.
The CL series unit will switch to SENDS ON FADER mode. The faders in the Channel Strip
section and Master section will move to the send levels of the signals that are routed from each
channel to the currently-selected MIX/MATRIX bus. The [ON] keys will also change to the SEND
ON status.
In SENDS ON FADER mode, the Function Access Area in the display will show the buttons that
enable you to switch between MIX 1-16 ON FADER mode and MIX 17-24/MATRIX ON FADER
mode, and the buttons that enable you to select the destination MIX/MATRIX buses.
3.
Use the MIX 1-16 and MIX 17-24/MATRIX select buttons to switch between MIX 1-
16 and MIX 17-24/MATRIX.
Now you can use the MIX/MATRIX bus select buttons to specify the destination MIX/MATRIX
buses.
4.
Use the MIX/MATRIX bus selection buttons in the function access area to select the
send-destination MATRIX bus.
NOTE
• Alternatively, press a SEND LEVEL knob in the SELECTED CHANNEL section to display a
popup window, from which you can select a MIX/MATRIX bus.
• You can also select a MIX/MATRIX bus by using the Bank Select keys and the [SEL] keys in the
Centralogic section. If you switch buses by pressing the [SEL] keys, the setting of the MIX 1-16
and MIX 17-24/MATRIX ON FADER switch buttons will also be change automatically.
• If you press the currently-selected MIX/MATRIX bus select button again, cue monitoring will be
turned on for the corresponding MIX/MATRIX channel. This method is convenient if you want to
monitor the signal that is being sent to the selected MIX/MATRIX bus.
5.
Use the faders in the top panel Centralogic section to adjust the send level from
the MIX and STEREO/MONO channels to the selected MATRIX bus.
NOTE
You can assign the SENDS ON FADER function to a USER DEFINED key. This lets you quickly
switch to SENDS ON FADER mode for a specific MIX/MATRIX bus, and quickly switch back
again.
6.
Repeat steps 4–5 to adjust the send level for other MATRIX buses in the same way.
7.
When you're finished adjusting the MATRIX send levels, press the X symbol in the
function access area.
The Function Access Area display will return to its prior state, and the CL console will exit SENDS
ON FADER mode and return to normal mode.
54
Output channels
Reference Manual