Switching The Entire Phantom Power Supply On/Off - Yamaha CL1 Reference Manual

3
Send point select buttons (MATRIX bus only)
Select the pre-fader send point from the input channel. These buttons correspond to the following
parameters.
Button Pre-fader send point
PRE EQ Immediately before the EQ
PRE FADER Immediately before the fader
4
PAN LINK button
This button appears only if two adjacent buses are paired in stereo and the bus type is set to VARI.
If the button is on, the pan setting of signals sent from input channels to the corresponding two
buses will link with the STEREO bus pan setting.
3.
Use the MIX1-16 tab and MIX17-24/MATRIX tab to access the buses whose settings
you want to edit.
4.
Use the buttons in the SIGNAL TYPE field to specify whether each bus will function
as STEREO (main parameters will be linked for two adjacent odd-numbered/even-
numbered buses) or MONOx2 (use as two monaural channels).
5.
Use the buttons of the PRE FADER SEND POINT/BUS TYPE field to select the
position from which the signal of the input channel will be sent.
In the case of a MIX bus, you can use this field to switch the type of bus (VARI or FIXED).
6.
As desired, turn the buttons in the PAN LINK field on or off.
In the PAN LINK field, you can specify whether the panning of the signal routed from an input
channel to the stereo bus will be linked with operation of the INPUT TO ST PAN knob (if the
input channel's SIGNAL TYPE is set to STEREO and BUS TYPE is set to VARI).
• If the PAN LINK button is on:
If the send-destination bus is stereo, the PAN knob that appears in the location of the SEND
LEVEL knob on the screens for input channels will be linked with the INPUT TO ST PAN knob.
• If the PAN LINK button is off:
The PAN knob that appears in the location of the SEND LEVEL knob of input channels in various
screens is not linked with INPUT TO ST PAN; it can be operated independently.
Switching the entire phantom power supply on/
off
1.
In the function access area, press the SETUP button to access the SETUP screen.
2.
In the center of the SETUP screen, press the +48V MASTER field's ON button or OFF
button.
If this button is off, phantom power will not be supplied even if the +48V button of an OMNI jack
input channel or TALKBACK IN is on.
NOTE
This +48V MASTER setting does not affect the inputs of external racks such as DANTE inputs
(I/O devices). Each rack has a +48V MASTER switch, and will operate according to its setting.
203
Other functions
Reference Manual