Samsung OfficeServ 100 System Administration Manual page 23

Samsung OfficeServ 100
Key Function
Inserts a flash ("F").
B
Inserts a pause ("P").
C
Used for pulse-to-tone conversion ("C"). If your system uses rotary (or pulse) dialling C.O.
D
lines, pressing D while entering a speed dial number causes all subsequent digits to be sent
as DTMF tones.
Used to hide digits. You may want to hide some phone numbers so that they will not show
E
in the display when you dial the speed dial number later. When you are programming the
phone number, press E before entering the digits you want to hide. The symbol "[" is dis-
played. All subsequent digits will be displayed as " " when the speed dial number is dialled.
If you want some digits to display, press E again ("]" is displayed) before entering these dig-
its.
(For example, if you program a speed dial number with the phone number 9-[0121]728765,
when you later dial this speed dial number the display shows "****728765".)
Note: When programming an outside number, enter the access code (e.g. 9 or 0) before you press E
to hide any digits.
Used to enter a new MMC and designate a name for a speed dial number.
F
(Note: The function of the 'A' key is described in
Open customer programming and follow these instructions.
ACTION
1. Press Transfer (or TRSF) 705
Display shows
2. Dial the speed bin desired (e.g., 505)
OR press the VOLUME keys to make the
selection and press the right soft key
to move the cursor
3. Enter the access code ( e.g., 9 – the
system automatically inserts a dash)
followed by the phone number (up to
24 digits)
4. Press the F key to toggle to
Speed Dial Names [MMC706, step 3, below]
to enter a name for this number OR press the
right soft key to return to step 2
5. Press Transfer (or TRSF) to store and exit
programming OR press SPEAKER to store and
advance to the next program
Program Station
Program System
System Administration Guide
Names, above.)
DISPLAY
SYS SPEED DIAL
500:
SYS SPEED DIAL
505:
SYS SPEED DIAL
505:9-121223456789
SYS SPEED NAME
505:
19