Toro 04353 Operator's Manual page 18

PREPARING THE MACHINE FOR MOW-
ING
To help align the machine for successive cutting passes, do the
following to the No. 2 and No. 3 cutting-unit baskets:
1. Measure in approximately 12 cm from the outer edge of
each basket.
2. Either place a strip of white tape or paint a line onto each
basket paralleling the outer edge of each basket (Fig. 13).
TRAINING PERIOD
Before mowing greens with the GREENSMASTER 3100, we
suggest that you find a clear area and practice starting and stop-
ping, raising and lowering the cutting units, turning, etc. This
will help you gain confidence in the performance of the
GREENSMASTER 3100.
IMPORTANT. If you shift to the No. 2 position while cut-
ting greens, no increase in speed will result. However, a sud-
den Increase In speed will develop when you actuate the lift
pedal. For safety, use only the No. 1 position for cutting
greens and the No. 2 position for transport.
1. Fluid level (warm)
2. Warning buzzer
3. Float down, switch closed
1. Clean the rod or screwdriver
2. Warning buzzer
3. Press down on the switch float
2
1. Alignment strip
2. Approx. 12 cm
18
3
Figure 11
LEAK ALERT!
1
3
Figure 12
4
3
1
Figure 13
3. Cut grass on right
4. Keep focal spot 2–3 meters
ahead of the machine
1
2
2