Toro 04353 Operator's Manual page 14

FUSE (Fig. 6)—The 20-amp fuse is part of the electrical cir-
cuit.
LEAK DETECTOR TEST/LIGHT SWITCH (Fig. 6) From
the middle operating position, move the switch rearward to
check the operation of the leak detector alarm and time delay.
Move the switch forward to operate optional headlights.
HOUR METER (Fig. 6)—Shows the total hours of machine
operation. The hour meter starts whenever the key switch is
turned to ON.
SEAT ADJUSTING HANDLE (Fig. 6)
SHIFT SELECTOR (Fig. 7)—Provides two traction selec-
tions, plus a NEUTRAL position. It is permissible to shift from
one selection to another while the machine is in motion. No
damage will result.
1. Neutral—Used for starting the engine.
2. No. 1 Position—Used for greens mowing operation.
3. No. 2 Position—Used for transport operation.
NOTE: If you operate the machine in reverse with the cutting
units down, they will be pulled off the lift arms.
STEERING ARM LOCKING LEVER (Fig. 7)—Rotate the
lever rearward to loosen, then raise or lower the steering arm for
comfort. Then rotate the lever forward to tighten.
To adjust the locking lever:
1. Rotate the lever rearward to loosen adjustment and move
the steering arm to its lowest position.
2. Loosen the lever set screw.
3. Rotate the adjusting bolt (left-hand thread) counter-clock-
wise to tighten, or clockwise to loosen the adjustment.
4. Tighten the set screw to lock the adjustment.
1. Shift selector
2. Steering arm locking lever
3. Set screw
4. Adjusting bolt
14
3
2
4
Figure 7
1