Toro 04383 Operator's Manual page 15

C. Bend the grass shield side deflectors outward until
they are flush with the cutting unit side plates
(Fig. 10).
1
2
Figure 10
1. Front shield assembly
2. Front shield mounting
studs
4. Thread a ball stud into each end of the cutting unit
front roller (Fig. 11).
Figure 11
1. Ball stud
5. Slide the cutting unit under the pull frame while
hooking the lift roller onto the lift arm. To facilitate
installation of the rear cutting unit, the pull frame can
be rotated and latched into a service position:
A. Lower the suspension system completely (cylinders
extended).
B. Lift the carrier frame by hand until the anti-scalp
rollers clear the brake linkage.
C. Lift up on the slotted link and rotate the pull frame
into the wire hook (Fig. 12).
3
3. Grass shield side
deflectors
1
2
Figure 12
1. Slotted link
D. With the cutting unit in position, release the wire
hook and rotate the pull frame to the operating
position. The slotted link locks automatically.
E. Attach the motor and pull links.
Important Do not operate the lift system when the
center cutting unit is in the service position. Damage
could result to the pull frame and clevis assembly.
Note: When installing cutting units with groomers, and
the groomer carton label does not read "with extension
brackets," Groomer Extension Kit, Part No. 99-4255, is
required.
6. Slide the sleeve back on each ball joint receiver and
hook the receiver onto the cutting unit ball stud
(Fig. 13).
2
Figure 13
1. Ball stud
2. Pull arm extension
1
2. Wire hook
1
3
6.06 in. (154 mm)
w/o groomer
3. Ball joint receiver
15