Installing The Mounting Plate To The Debris Blower Frame - Toro 44547 Operator's Manual

1
5
1. Roll pin
2. Safety chain (2)
3. Drive shaft
3. Secure them with a roll pin (Figure 9).
4. Secure the drive shaft to the gear box shaft with two
5/16 x 1–3/4 inch bolts and 5/16 inch lock nuts
(Figure 9).
5. Torque the bolts and lock nuts to 18 to 25 N-m (175
to 225 in-lb).
6. Remove the cable tie keeping the drive shaft together
7. Secure the safety chain to blower frame (Figure 9).
3
Installing the Mounting Plate
to the Debris Blower Frame
Parts needed for this procedure:
1 Mounting plate
4 Bolt, 1/2 x 1-1/4 inches
4 Lock nut, 1/2 inch
Procedure
1. Remove the bolts securing the mounting plate to the
crate (Figure 10).
2
4
Figure 9
4. Bolts, 5/16 x 1–3/4 inch
5. Lock nuts, 5/16 inch
6. Gear box shaft
3
G02391 1
1. Mounting plate
2. Install the mounting plate to the debris blower frame
with (4) 1/2 x 1-1/4 inch bolts and (4) 1/2 inch
locknuts (Figure 11). Use the lower set of holes on
each side of the mounting plate when installing. Torque
the bolts to 92 to 113 N-m (68 to 82 ft-lb)
3
1. Mounting plate
2. Bolt (4)
9
1
G021682
Figure 10
1
Figure 11
3. Locknut (4)
2
G021677