Mounting The Debris Blower To The Traction Unit - Toro 44547 Operator's Manual

4
Mounting the Debris Blower to
the Traction Unit
Parts needed for this procedure:
1 Debris blower assembly
1 Locking pin
1 Hair pin cotter
Procedure
1. Remove any attachment from the front of the machine.
2. Move the traction unit into position behind the
attachment adapter.
3. Raise the traction unit adapter into the attachment
adapter.
Note: If the jack stand is raised slightly higher than
the castors, the adapter will be easier to install.
4. Insert the locking pin through the adapters and secure
with a hairpin cotter (Figure 12).
1
2
Figure 12
1. Locking pin
5. Install the drive shaft to the quick attach frame by
sliding the quick coupler onto the shaft (Figure 13).
G023910
2. Hairpin cotter
1. Drive shaft
6. Secure the safety chain to the quick attach frame
(Figure 13).
7. Remove the dust plugs from the hydraulic couplers
and make sure couplers are free of any dirt or
contamination.
8. Connect the attachment hydraulic hose couplers to the
hydraulic couplers on the traction unit rear auxiliary
hydraulic power kit.
Important: Whenever the hydraulic hose
couplers are disconnected, make sure the dust
plugs are cleaned and then installed to prevent
contamination from entering either hydraulic
system.
10
1 2
G021678
Figure 13
2. Quick attach frame shaft