Setup; Mounting The Debris Blower To The Traction Unit - Toro 08759 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Media and Additional Parts
Description
Operator's Manual
Parts Catalog
Declaration of Conformity
Note: Determine the left and right sides of the machine
from the normal operating position.
Note: To operate the debris blower, the traction unit
must be equipped with the Rear Remote Hydraulics Kit,
Model 08781.
1
Mounting the Debris Blower to
the Traction Unit
Parts needed for this procedure:
1 Debris blower assembly
Procedure
1. Remove any attachment from the rear of the
machine.
2. Back the traction unit into position behind the
attachment adapter.
Note: Make sure the locking lever (Figure 3) is
pivoted to the left (unlocked position) as viewed
from the rear of the machine.
Description
Debris blower assembly
No parts required
No parts required
Qty.
1
–
–
Qty.
1 Review before operating machine
1 Use to reference product part numbers
1
2
1. Attachment adapter
3. Raise the traction unit adapter into the attachment
adapter.
6
Use
Mount the debris blower to the traction
unit
Adjust the link assembly
Grease the blower
Use
G003810
Figure 3
2. Locking lever
1