Sanyo MCO-19M Service Manual page 99

Setting procedures for MCO-20AIC/MCO-18AIC/MCO-18M/MCO-18AC
When use MCO-21GC(the automatic switcher of CO
gas switching mode according to the following procedures.
Description of operation
1 Turn the power switch ON.
2 Press CAL key for 5 seconds.
3 By pressing
the figure to F03.
4 Press ENT key.
5 By pressing
the figure to 384
6 Press ENT key.
7 Press CAL key for 5 seconds.
8 By pressing
the figure to F08
9 Press ENT key.
10 By pressing
only the left digit figure to 1.
NOTE: Do not change center and
right digit figure.
11 Press ENT key.
CO gas supply
2
line indicator A
MCO-20AIC/18AIC/18AC
key and key, set
key and key, set
key and key, set
key and key, set
CO gas supply
2
line indicator B
gas supply line), it is necessary to set in automatic
2
Key Indication after operation
operated
The current
- displayed.
The left digit in the temperature indicator is
CAL flashed.
In CO density
2
ENT "000" is displayed.
The current
ENT displayed.
The left digit in the temperature indicator is
CAL flashed.
In CO density indicator, "0**"
2
ENT is displayed and the right
digit is flashed.
Setting of MCO-21GC is finished.
ENT The current
displayed.
CO gas supply line indicator A is lit.
2
(For MCO-18M, CO
is lit.)
CO gas supply
2
line indicator
- 96 -
chamber temperature
F 0 3
indicator,
F 0 3 0 0 0
F 0 3 3 8 4
chamber temperature
F 0 8
F 0 8 0 * *
F 0 8 1 * *
" " means "0" or "1".
chamber temperature
gas supply line indicator
2
N /O
2 2
line indicator
MCO-18M
is
is
is
gas supply