Toro 25430 Operator's Manual page 48

Battery Charging Table
Charger Setting
4 to 6 amperes
25 to 30 amperes
5. When the battery is fully charged, unplug the charger
from the electrical source, then disconnect the charger
leads from the battery posts
Replacing a Fuse
1. Remove the right side panel; refer to
Side Panels (page 36).
2. Rotate the battery-disconnect switch counterclockwise
to the Off position
Figure 60
1. Battery-disconnect switch
in the On position
3. Replace the open (blown) fuse in the fuse block with a
new fuse that has an equivalent amperage value
61).
Charging Time
30 minutes
10 to 15 minutes
(Figure 59).
Removing the
(Figure 60).
2. Battery-disconnect switch
in the Off position
1. Fuse block
4. Rotate the battery-disconnect switch clockwise to the
On position
5. Install the right side panel; refer to
Panels (page
(Figure
48
Figure 61
(Figure 18).
Installing the Side
37).