Toro 25430 Operator's Manual page 42

Installing the Air-cleaner Cover
1. Align the dust cap on the air-cleaner cover to the 7
o'clock position.
2. Align the air-cleaner cover onto the cleaner housing
(Figure 49).
3. Rotate the air-cleaner cover clockwise so that the dust
cap is at the 8 o'clock position
4. Push the latch for the air-cleaner cover inward until the
cover is fully seated
5. Install the left side panel; refer to
Panels (page 37).
Replacing the Primary Element
Important: Replace the primary air-cleaner element
when the restricted air-cleaner light comes on.
1. Remove the air-cleaner cover; refer to
Air-cleaner Cover (page
2. Pull the primary air-cleaner element outward and
remove it from the air-cleaner housing
Figure 50
1. Primary air-cleaner element
Note: Discard the old air-cleaner element.
3. Use a clean damp cloth to clean the inside of the
cleaner housing (Figure
4. Use a light to inspect the new element for damage; if
the element is damaged, replace it.
Note: Check the date of manufacture on the end of
the new air-cleaner element. Do not install an element
that is more than 5 years old.
5. Write the current date and the engine hours on the end
of the element with a permanent marking pen.
(Figure 46).
(Figure 46).
Installing the Side
Removing the
41).
(Figure
49).
6. Insert the new primary air-cleaner element into the
air-cleaner housing
Note: Ensure that the air-cleaner element is fully
seated in the housing.
7. Install the air-cleaner cover; refer to
Air-cleaner Cover (page
8. Check the restricted air-cleaner light; refer to
the Restricted Air-cleaner Light (page
Replacing the Secondary Element
Note: Replace the secondary air-cleaner element after you
have replaced the primary air-cleaner element 3 times or if
the air-cleaner restriction light comes on while the engine is
running and you have already replaced primary air-cleaner
element.
Important: Do not clean either the primary element
or the secondary element.
1. Remove the air-cleaner cover; refer to
Air-cleaner Cover (page
50).
2. Pull the primary air-cleaner element outward and
remove it from the air-cleaner housing; refer to
Replacing the Primary Element (page
Pull the secondary air-cleaner element outward and
remove it from the air-cleaner housing.
1. Secondary air-cleaner element
Note: Discard the old air-cleaner element.
3. Clean the inside of the cleaner housing with a clean,
damp cloth
4. Insert the new secondary air-cleaner element into the
air-cleaner housing
42
(Figure 50).
Installing the
42).
41).
Figure 51
(Figure 49).
(Figure 51).
Checking
41).
Removing the
42).
(Figure 51).