Toro 25430 Operator's Manual page 44

Figure 53
1. Fuel tank
2. Drain plug
3. When clean fuel appears, install the drain plug and
tighten it securely (Figure
4. Check the fuel tank drain plug for leaks.
Siphoning Water from the Fuel Tank
Note: Siphoning water from the fuel tank is an alternative
to draining water from the fuel tank; refer to
from the Fuel Tank (page
1. Remove the fuel cap from the fuel tank
Figure 54
1. Intake hose (bottom of the
tank)
2. Fuel cap
2. Route the intake hose of the siphoning equipment
through the filler neck of the fuel tank and to the
bottom of the tank
3. Direct the discharge hose of the siphoning equipment
into a drain pan (Figure
4. Siphon the tank until clean fuel appears.
5. Remove the siphoning equipment from the tank.
6. Install the fuel cap onto the filler neck of the fuel tank
(Figure 54).
3. Drain pan
53).
Draining Water
43).
(Figure
3. Siphoning equipment
4. Drain pan
(Figure 54).
54).
Replacing the Fuel Filters
Replacing the Secondary Fuel Filter
Service Interval: Every 500 hours
1. Remove the left side panel; refer to
Panels (page
2. Remove the secondary fuel filter and fuel-water
separator as follows:
A. Clean the secondary fuel filter and the surrounding
area.
B. Completely drain the fuel-water separator; refer to
Draining the Fuel-water Separator (page
C. Firmly grasp the secondary fuel-filter element,
rotate the water sensor counterclockwise, and
remove the water sensor
Note: Retain the water sensor, but discard the
O-ring.
54).
1. Filter adapter
2. Secondary filter element
3. O-ring
4. Water sensor
5. Fuel hose
D. Firmly grasp the secondary fuel-filter element,
rotate it counterclockwise, and remove it from the
filter adapter
Note: Discard the filter element.
E. Clean the filter adapter with a clean rag.
Important: Do not use a filter wrench to
tighten the filter. You could damage the filter
and cause a leak.
44
Removing the Side
36).
(Figure 55).
Figure 55
6. Hose clamp
7. Arrow
8. Primary fuel filter
9. Fitting
(Figure 55).
43).