Table of Contents
Advertisement
2
Checking the Tire Pressure
No Parts Required
Procedure
The tires are over inflated for shipping. Therefore, release
some of the air to reduce the pressure. The correct air
pressure for non-cab models is 103 kPa (15 psi) in the front
tires and 172 kPa (25 psi) in the rear tires. If a cab is installed
on the machine, the front and rear tires should be inflated to
172 kPa (25 psi).
3
Checking the Fluid Levels
No Parts Required
Procedure
1. Check the hydraulic fluid level before starting the
engine, refer to
Checking the Hydraulic System (page
44).
2. Check the engine oil level before starting the engine,
refer to
Checking the Engine-Oil Level (page
3. Check the cooling system before starting the engine;
refer to
Checking the Cooling System (page
4
Installing the Drive Shaft to an
Optional Mower Deck or QAS
Parts needed for this procedure:
1
Driveshaft
4
Screw, 5/16 x 1–3/4 inch
4
Lock nut, 5/16 inch
2
Roll pin, 3/16 x 1–1/2 inch
Procedure
Note: PTO drive shaft installation is easier if the machine is
positioned on a hoist.
1. Park machine on a level surface, stop engine, engage
parking brake and remove key from the ignition switch.
Do not start the engine and engage the
PTO switch when the PTO drive shaft is
disconnected from the cutting deck. If the
engine is started and the PTO shaft is allowed
to rotate, serious personal injury and machine
damage could result. Before the PTO drive
shaft is disconnected from the cutting deck,
disconnect PTO solenoid coil connector
from wire harness to prevent unintentional
engagement of the PTO clutch.
2. To prevent the unintentional engagement of the PTO
clutch, disconnect the wire harness electrical connector
from the PTO solenoid valve coil connector
34).
1. Wire harness electrical connector
39).
3. Position the PTO drive shaft under the front of the
machine. Make sure that the drive shaft slip shaft yoke
(Figure
G018340
1. Transmission drive shaft
2. Capscrew
3. PTO shaft
13
WARNING
1
Figure 4
5) is toward the transmission PTO shaft.
4
5
Figure 5
4. Locknut
5. Roll pin
(Figure
4).
G018339
1
2
3
Advertisement
Table of Contents
