Table of Contents
Advertisement
Figure 47
1. Transmission-case
drain-plug
2. Filter
4. Clean the area around the hydraulic-oil filter and
remove it
(Figure
47).
5. Immediately install a new hydraulic-oil filter.
6. Install the hydraulic reservoir and transmission case
drain plugs.
7. Fill the reservoir to the proper level (approximately 17
L [18 qt]).
8. Start the engine and check for oil leaks. Allow the
engine to run for about 5 minutes, then shut it off.
9. After 2 minutes, check the level of the hydraulic fluid;
refer to
Checking the Hydraulic System (page
3. Hydraulic-reservoir
drain-plug
44).
Cleaning
Cleaning under the Mower
Service Interval: Before each use or daily
Remove the grass buildup under the mower daily.
1. Disengage the PTO, release the traction pedal to the
Neutral position and set the parking brake.
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Raise the mower to the transport position.
4. Raise the front of the machine by using jack stands.
5. Thoroughly clean the underside of the mower with
water.
Waste Disposal
Engine oil, batteries, hydraulic oil, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
45
Advertisement
Table of Contents
