Product Overview; Controls - Toro 31201 Operator's Manual

4. Align the spline and roll pin hole of drive shaft yoke
with the transmission shaft.
5. Slide PTO drive shaft end yoke onto the transmission
PTO shaft.
6. Secure the end yoke of the PTO drive shaft as follows:
A. Install the roll pin in the end yoke and shaft.
B. Install the capscrews thru the drives shaft end
yoke.
C. Install and tighten the lock nuts to secure the end
yoke to the PTO shaft. Torque the lock nuts to 20
to 25 N-m (175 to 225 in-lb).
Note: Retain the remaining capscrews, locknuts
and roll pin to secure the other end of the drive
shaft to the attachment gear box shaft.
7. Lubricate the PTO drive shaft grease fittings.
8. After the other end of the drive shaft is connected
to the attachment gear box shaft, connect the wire
harness electrical connector to the PTO solenoid valve
coil connector (Figure 4).

Product Overview

Controls

Become familiar with all the controls before you start the
engine and operate the machine.
Traction Pedal
The traction pedal (Figure
operation. Press the top of the pedal to move forward and the
bottom to move rearward. Ground speed depends on how
far you press the pedal. For no load, maximum ground speed,
fully press the pedal while the throttle is in the Fast position.
To stop, reduce foot pressure on the traction pedal and allow
it to return to the center position.
1. Parking brake
2. Brake pedal
3. Tilt steering pedal
Brake Pedal
The brake pedal is used in conjunction with the brake pedal
latch to engage and disengage the parking brake
stop the machine, release the traction pedal and allow it to
return to the center position. The brake can assist in stopping
in an emergency situation.
Parking Brake
To engage the parking brake, push down on the brake pedal
and press the top forward to latch
parking brake, press the brake pedal until the parking-brake
latch retracts.
14
6) controls the forward and reverse
Figure 6
4. Traction pedal
5. Mow speed limiter
(Figure
(Figure 6). To release the
6) To