Install Ce Decals; Installing The Hood Latch (Ce Only) - Toro 30849 Operator's Manual

1. Positive (+) battery cable
Important: If the battery is ever removed, make
sure that the battery clamp bolts are installed
with the bolt heads positioned on the bottom
side and the nuts on the top side. If the clamp
bolts are reversed, they may interfere with the
hydraulic tubes when shifting the cutting units.
8. Coat both battery connections with Grafo 112X
(skin over) grease, Toro Part No. 505-47, petroleum
jelly, or light grease to prevent corrosion.
9. Slide the rubber boot over the positive terminal to
prevent a possible short from occurring.
10. Install the battery cover.
2

Install CE Decals

Parts needed for this procedure:
1 Warning decal (104–5181)
1 Warning decal (93–3558)
Procedure
If this machine will be used for CE, affix the warning
decal 104–5181 over English warning decal 108–9015.
Also, affix the warning decal 93–3558 over the English
instructions on the control panel decal 108–9006.
Figure 4
2. Negative (–) battery cable
3
Installing the Hood Latch (CE
Only)
Parts needed for this procedure:
1 Lock bracket
2 Rivet
1 Washer
1 Screw, 1/4 x 2 inches
1
Locknut, 1/4 inch
Procedure
1. Unhook the hood latch from the hood latch bracket.
2. Remove the (2) rivets securing the hood latch bracket
to the hood (Figure 5). Remove the hood latch
bracket from the hood.
2
1. Hood latch bracket
3. While aligning the mounting holes, position the CE
lock bracket and the hood latch bracket onto the
hood. The lock bracket must be against the hood
(Figure 6). Do not remove bolt and nut assembly
from the lock bracket arm.
15
1
G012628
Figure 5
2. Rivets