Controls System Maintenance; Adjusting The Throttle - Toro 03206 Operator's Manual

2. Push down and forward on the spring end (Figure 67)
to unhook it from the bracket and release tension
on the spring.
Figure 67
1. Hydrostat drive belt
3. Replace the belt.
4. Reverse the procedure to tension the spring.
2. Spring end
Controls System
Maintenance

Adjusting the Throttle

1. Position the throttle lever rearward so that it stops
against the control panel slot.
2. Loosen the throttle cable connector on the injection
pump lever arm (Figure 68).
1. Injection pump lever arm
3. Hold the injection pump lever arm against the low
idle stop and tighten the cable connector.
4. Loosen the screws securing the throttle control to
the control panel.
5. Push the throttle control lever all the way forward.
6. Slide the stop plate until it contacts the throttle
lever, and tighten the screws that secure the throttle
control to the control panel.
7. If the throttle does not stay in position during
operation, torque the locknut used to set the friction
device on the throttle lever to 40–55 inch-lb (5–6
N-m).
Note: The maximum force required to operate the
throttle lever should be 20 lb (27 N-m).
49
Figure 68