Servicing The Spark Plug - Toro 22600 SGR-6 Operator's Manual

6. When the oil has drained completely, install the plug
and wipe up any spilled oil.
Note: Dispose of the used oil at a certified recycling
center.
7. Remove the oil fill cap and slowly pour approximately
80 percent of the specified amount of oil into the
engine (Figure 16).
8. Slowly add additional oil to bring the oil level to the
upper limit mark on the dipstick. Refer to
Engine-Oil Level (page
9. Install the oil fill cap.
Cleaning the Sediment Cup
Service Interval: Every 100 hours
Yearly or before storage
Underneath the fuel valve is a sediment cup to catch dirt in
the fuel.
1. Move the fuel valve to the O
to the left.
2. Unscrew the sediment cup. Make sure not to misplace
the O-ring (Figure
1. Sediment cup
3. Clean the reservoir and the O-ring using a cleaning
solvent and dry carefully.
Note: Make sure not to misplace the O-ring.
4. Put the O-ring in place in the groove of the cup and
replace the sediment cup.
5. Turn the fuel valve to the O
the right, and check for leaks.
Note: If it leaks, replace the O-ring.
Checking the
11).
position, all the way
FF
17).
Figure 17
2. O-ring
position, all the way to
N

Servicing the Spark Plug

Service Interval: Every 100 hours—Check the spark plugs.
Ensure that the air gap between the center and side electrodes
is correct before installing the spark plug. Use a spark plug
wrench for removing and installing the spark plug and a
gapping tool/feeler gauge to check and adjust the air gap.
Install a new spark plug if necessary.
Type: BPR6ES (NKG) or equivalent
Air Gap: 0.70 to 0.80 mm (0.28 to 0.031 inch)
Removing the Spark Plug
1. Lower the grinder and shut off the machine; Refer to
Shutting Off the Engine (page
2. Pull the wire off the spark plug
1. Spark plug
3. Clean around the spark plug.
4. Remove the spark plug and the metal washer.
16
12).
(Figure 18).
Figure 18
2. Wire