Checking The Engine-Oil Level - Toro 22600 SGR-6 Operator's Manual

Filling the Fuel Tank
1. Park the machine on a level surface, lower the grinder,
and shut off the engine.
2. Allow the engine to cool.
3. Clean around the fuel tank cap and remove it
View may vary depending on model
1. Fuel-tank cap
4. Add unleaded gasoline to the fuel tank, until the level is
6 mm to 13 mm (1/4 to 1/2 inch) below the bottom of
the filler neck.
Important: This space in the tank allows gasoline
to expand. Do not fill the fuel tank completely full.
5. Install the fuel tank cap securely.
6. Wipe up any gasoline that may have spilled.

Checking the Engine-Oil Level

Service Interval: Before each use or daily
1. Tilt the machine so the engine is level, and shut off
the engine.
2. Allow the engine to cool.
3. Clean around the oil dipstick.
4. Remove the dipstick and wipe the end clean.
5. Slide the dipstick fully into the dipstick tube without
threading it into the filler neck.
6. Pull the dipstick out and look at the end; the oil should
be to the top of the upper limit range
(Figure
Figure 9
(Figure
9).
1. Oil dipstick
Important: Running the engine with low oil level
can cause engine damage. This type of damage is
not covered by warranty.
The engine is equipped with an oil alert system
that will automatically shut off the engine before
the oil level falls below the safe limit.
7. If the oil level is low, slowly pour only enough oil into
the crankcase to raise the level to the upper limit.
Important: Do not overfill the crankcase with oil
because the engine may be damaged.
8. Replace the dipstick.
10).
11
Figure 10