Servicing The Fuses - Toro 74450TE Z400 Z Master Operator's Manual

1. Disengage the PTO, move the motion control levers
to the neutral locked position, and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Unlatch the seat and tilt the seat up.
4. First disconnect the negative battery cable and
ground wire from the negative (-) battery terminal
(Figure 42).
5. Slide the red terminal boot off the positive (red)
battery terminal. Then remove the positive (red)
battery cable (Figure 42).
1. Battery
2. Terminal boot
3. Positive battery cable
4. Negative battery cable
5. Ground wire
6. Bolt (1/4 x 3/4 inch)
6. Remove both wing nuts (1/4 inch) securing the
battery clamp (Figure 42).
7. Remove the battery.
Installing the Battery
1. Position battery in the tray with the terminal posts
toward the engine (Figure 42).
2. First, install the positive (red) battery cable to
positive (+) battery terminal.
3. Then install the negative battery cable and ground
wire to the negative (-) battery terminal.
4. Secure the cables with 2 bolts (1/4 x 3/4 inch),
2 washers (1/4 inch), and 2 locknuts (1/4 inch)
(Figure 42).
Figure 42
7. Washer (1/4 inch)
8. Locknut (1/4 inch)
9. Battery clamp
10. J-bolts
11. Wingnut (1/4 inch)
5. Slide the red terminal boot onto the positive (red)
battery post.
6. Secure battery with J-bolts, hold down clamp and
2 washers (1/4 inch), and 2 wing nuts (1/4 inch)
(Figure 42).
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged
(1.265 specific gravity). This is especially important
to prevent battery damage when the temperature is
below 32°F (0°C).
1. Charge battery for 10 to 15 minutes at 25 to 30 amps
or 30 minutes at 4-6 amps.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the
charger leads from the battery posts (Figure 43).
1. Positive Battery Post
2. Negative Battery Post
3. Install the battery in the machine and connect the
battery cables; refer to Installing the Battery.
Note: Do not run the machine with the battery
disconnected, electrical damage may occur.

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short.
35
Figure 43
3. Red (+) Charger Lead
4. Black (-) Charger Lead