Positioning The Seat; Unlatching The Seat; Pushing The Machine By Hand - Toro 74450TE Z400 Z Master Operator's Manual

1. Place your foot onto lift assist lever.
2. Press on the lift assist lever while pulling up on the
height-of-cut lever (Figure 26).
Figure 26

Positioning the Seat

The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
To adjust, move the lever sideways to unlock seat
(Figure 27).
Slide the seat to the desired position and release lever
to lock in position.
G008962
Figure 27

Unlatching the Seat

Push the seat latch rearward to unlatch the seat.
This will allow access to the machine under the seat
(Figure 28).
1. Seat latch
2. Fuel cap

Pushing the Machine by Hand

Important: Always push the machine by hand.
Never tow the machine because hydraulic damage
may occur.
Pushing the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off. Move the levers to neutral locked
position and apply parking brake. Remove the key.
2. Rotate the by-pass valves counterclockwise 1 turn
to push. This allows hydraulic fluid to by-pass the
pump enabling the wheels to turn (Figure 29).
Important: Do not rotate by-pass valves more
than 1 turn. This prevents valves from coming
out of the body and causing fluid to run out.
3. Disengage parking brake before pushing.
Changing to Machine Operation
Rotate the by-pass valves clockwise 1 turn to operate
machine (Figure 29).
Note: Do not over tighten the by-pass valves.
The machine will not drive unless by-pass valves are
turned in.
23
Figure 28
3. Seat