Cleaning Under The Belt Cover; Cleaning The Seed Gate - Toro 33512 Operator's Manual

CAUTION
The machine may dislodge material from
under the housing.
• Wear eye protection.
• Stay in the operating position (behind
the handle).
• Do not allow bystanders in the area.
3. Turn the fuel shutoff valve to the O
and drain the fuel from the fuel tank; refer to
Draining the Fuel Tank (page
4. Tilt the machine rearward until the upper handle
rests on the ground, and place a jack stand
under the machine.
Note:
If necessary, use 2 people to tilt the
machine rearward.
5. Remove the debris with a hardwood scraper or
other suitable device. Avoid burrs and sharp
edges.
6. Return the machine to the upright position.
7. Fill the fuel tank.
8. Connect the wire to the spark plug.
Cleaning under the Belt
Cover
Service Interval: Every 50 hours
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Remove and retain the 4 bolts, lock washers,
and 2 spacers securing the belt cover to the left
side of the machine.
4. Remove the cover, and brush out all the debris
around the belt area.
5. Install the belt cover, and tighten all the
hardware.
6. Connect the wire to the spark plug.

Cleaning the Seed Gate

1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Drain the fuel from the fuel tank; refer to
the Fuel Tank (page
4. Tilt the machine rearward until the upper handle
rests on the ground, and place a jack stand
under the machine.
position,
FF
25).
Draining
25).
Note:
If necessary, use 2 people to tilt the
machine rearward.
5. Clean the debris between the frame and the
seed gate.
6. Lubricate the sliding surface between the frame
and seed gate with a dry lubricant.
7. Return the machine to the upright position.
8. Fill the fuel tank.
9. Connect the wire to the spark plug.
32