Using The Headlights; Positioning The Tilt Steering Wheel; Pushing The Machine By Hand - Toro 266H Wheel Horse 72052 Operator's Manual

2. Slide the seat to the desired position and tighten the
knobs.
1
Figure 15
1. Adjustment knob

Using the Headlights

The headlights are turned on with a separate position,
lights, of the ignition switch (Fig. 16). The lights are on
while the ignition switch is in the lights position even with
the engine off. Remove the key when the machine is left
unattended so lights can not be turned on discharging the
battery.
Figure 16
1. Lights
Positioning the Tilt Steering
Wheel
The steering wheel has four tilt locations. Position the
steering wheel where you have the best control of the
machine and are most comfortable.
1. Lift the tilt lever to release the lock (Fig. 17).
2. Move the steering wheel to a comfortable position;
then release the lever to lock.
1. Tilt lever

Pushing the Machine by Hand

Important
tow the machine because transaxle damage may occur.
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off.
2. Move the drive control rod to the push position. This
disengages the drive system and allows the wheels to
1
turn freely (Fig. 18).
To Operate the Machine
1. Move the drive control rod to the operate position
(Fig. 18).
Note: The machine will not drive unless the drive control
1208
rod is in the operate position.
1
2
1. Operate position
2. Push position
20
1
Figure 17
2. Steering wheel
Always push the machine by hand. Never
Figure 18
3. Drive Control Rod
2
1203b
3