Operating The Power Take Off (Pto); Testing The Safety Interlock System - Toro 266H Wheel Horse 72052 Operator's Manual

7. After the engine starts, move the choke lever to off
(Fig. 6). If the engine stalls or hesitates, move the
choke lever back to on for a few seconds. Then move
the throttle lever to desired setting. Repeat this as
required.
2
3
1
1206
Figure 6
1. PTO—Off
2. Choke–On
3. Choke–Off
1
Figure 8
1. Off
2. Lights
Stopping the Engine
1. Push the PTO (power take off) to off (Fig. 9).
2. Move the throttle lever to slow (Fig. 7).
3. Let engine idle for 30–60 seconds.
4. Turn the ignition key to off (Fig. 8).
Operating the Power Take Off
(PTO)
The power take off (PTO) engages and disengages power
to the electric clutch.
1
2
1207
Figure 7
1. Fast
2. Slow
2
3
4
1208
3. Run
4. Start
16
While the ignition key is in run or lights position and the
power take off (PTO) is engaged on, the PTO light, in the
Indicator Module, will be on. When this light is on it is a
reminder the starter will not crank and to turn the off PTO
before getting off the tractor.
Engaging the Power Take Off (PTO)
1. Depress the brake pedal to stop the machine.
2. Pull the power take off (PTO) to on (Fig. 9).
1
Figure 9
1. Off-Disengaged
Disengaging the Power Take Off (PTO)
1. Depress the brake pedal to stop the machine.
2. Push the power take off (PTO) to off (Fig. 9).
Testing the Safety Interlock
System
Caution
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
Do not tamper with the interlock switches.
Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Understanding the Safety Interlock
System
The safety interlock system is designed to prevent the
engine from starting unless:
You are sitting on the seat
2
1206
2. On-Engaged