Important Instructions - Sharp AX-1600R Operation Manual

IMPORTANT INSTRUCTIONS

Read Carefully Before Cooking in SuperSteam & Pure Steam
WATER TANK
To fill the water tank with room temperature
water suitable for drinking (fi ltered) is a must for
SuperSteam and Pure Steam in both Automatic
and Manual Cooking. Be sure to follow the
directions below.
1. Pull the water tank toward you to remove. (Figure 1)
2. Wash the water tank and lid for the fi rst time.
3. Fill the water tank with room temperature water
suitable for drinking (fi ltered) through the lid to
the 2 mark (MAX mark) each time you begin to
cook. (Figure 2) Do not fi ll the water tank over the
2 mark (MAX mark).
4. Make sure the lid is closed fi rmly.
5. Install the water tank by pushing fi rmly. (Figure 3)
6. After cooking, empty the water tank and wash
the water tank and the lid.
Figure 1
DRIP TRAY
Be sure to cook with drip tray in position and
follow the directions below.
The drip tray and the lid are packed with the oven.
Place the drip tray and lid under the oven door
as shown in Figure 4. This drip tray collects the
condensation from the oven door.
To remove the drip tray: Pull the drip tray toward
you with both hands.
* Make sure water is not dripping down before
removing the drip tray.
To replace the drip tray: Place the drip tray onto the right
and left hooks under the oven and push fi rmly as shown in
Figure 4. Insert the drip tray horizontally when you attach it.
Improper use may cause the damage to the hooks.
If " Replace drip tray" or " Empty drip tray and
replace" is as shown in the display, remove and then
replace the drip tray correctly.
WARNINGS:
1. The oven will become very hot after cooking and draining water function.
2. Do not open the oven with your face close to the oven. Steam from the oven may cause burns.
3. Make sure that the oven has cooled before emptying the water tank and the drip tray and then wipe the oven cavity.
4. Do not touch the water directly as water in the drip tray may be hot.
AX1600 En,P01-20 6 AX1600 En,P01-20 6
NOTES:
1. Do not use any other liquids like distilled water,
R.O water, mineral water and etc.
2. An insuffi cient amount of water in the water tank
may cause an undesired result.
3. We recommend that you empty the water tank
every time after cooking. Do not leave the water
tank fi lled with water in the oven over a day.
4. If any messages, such as " Fill water tank with
water", are as shown in the display during cooking,
refer to Troubleshooting Chart on page E-26.
5. Do not drop or damage the water tank. Heat may
cause the water tank to change shape. Do not
use a damaged water tank. Contact a SERVICE
CENTRE APPROVED BY SHARP.
6. There may be a few water drops when removing
the water tank. Wipe the oven dry with a soft cloth.
7. Do not block the air holes on the lid of the water
tank. It will cause trouble during cooking.
8. A small amount of water will drain into the drip tray
when the water tank is removed. Empty after cooking.
Figure 2
Empty the drip tray after each time you cook. Empty,
rinse thoroughly, dry and replace. Failure to empty may
cause the drip tray to overflow. Cooking repeatedly
without emptying the drip tray may cause it to overfl ow.
Hooks
Figure 4
E – 6
Figure 3
Drip tray
Drip tray lid
15/08/17 17:17 15/08/17 17:17