Important Safety Instructions - Sharp MICROWAVE DRAWER SMD2489ES Operation Manual

CAUTION FOR WIRELESS LAN
CAUTION FOR USAGE ABOUT WI-FI
• Operation cannot be guaranteed near Bluetooth
communications devices using the same frequency (2.4
GHz) as this product or specified low power wireless devices.
There may also be issues in locations with devices that emit a
magnetic field, such as microwave ovens, as well as locations
with static electricity or radio disturbance, all of which can
interfere with the Wi-Fi signal.
• Wireless connection and performance cannot be guaranteed
for all routers or housing environments. In the following
places, it is possible the Wi-Fi cannot reach or is disconnected:
inside of a building made with concrete, reinforced metal, near
an obstruction (e.g., a wall) or near a wireless communications
device using the same frequency.
• Wireless LAN of this product corresponds to channels 1-13.
It is not available to communicate with routers set up to other
channels.
CAUTION FOR PERSONAL INFORMATION
(RELATED TO SECURITY)
• Using a wireless LAN device has the possibility of
interception when using Wi-Fi, regardless of password setting.
• Depending on the location where you are connecting your
oven, ensure you have the right/authority to connect the
appliance to the available Wi-Fi network.
• If disposing of, giving away or selling the unit, be sure to
Reset Wi-Fi Settings as described in this manual. The wire-
less LAN function of the unit should be initialized (reset) in
case of handover to a third party to avoid illegal access from
unauthorized parties.
MINIMUM REQUIREMENTS FOR WI-FI/ROUTER
SPECIFICATIONS:
• IEEE 802.11 b/g/n compatible WLAN
• 72.2Mbps receive and transmit PHY rate using 20MHz
bandwidth
• 150Mbps receive and transmit PHY rate using 40MHz
bandwidth
• 802.11i (WPA, WPA2). Open, shared key, and pair-wise key
authentication services
• Wi-Fi WPS support

IMPORTANT SAFETY INSTRUCTIONS

wireless
®
IMPORTANT REGULATORY
INFORMATION
Any changes or modifications to the appliance
CAUTION
not expressly approved by the party responsible for compliance
could void the user's authority to operate the appliance.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
SHARP HOME USE MICROWAVE DRAWER
MODELS # SMD2489ES, SMD2479JS
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
• Contains FCC: RX3-B01
• Contains IC: 2878F-B01
Responsible Party:
Sharp Electronics Corporation
100 Paragon Drive, Montvale, NJ 07645
TEL: 1-800-BE-SHARP
www.sharpusa.com
5