Reader Mode And Authentication - Samsung SSA-R2010 User Manual

READER MODE AND AUTHENTICATION

Reader Mode
1. In Reader mode, any recognized user ID or status will be transmitted to the controller.
2. If the user ID and fi ngerprint are authenticated, the corresponding card ID will be displayed.
3. If they are not authenticated, an error signal will be output.
How to get authenticated if set to RF Only mode or if registered in RF
Only mode
1. Present the registered card to the reader.
2. When the card is authenticated successfully, you will hear a long beep with the green indicator turned on.
3. The user ID will be displayed according to the specifi ed output format.
How to get authenticated if set to RF+ Finger mode and registered in
RF+ Finger mode
1. Present the registered card to the reader.
2. When the card is recognized, the red lamp on the scanner turns on.
3. Place the registered fi ngerprint on the scanner.
4. When the fi ngerprint is authenticated successfully, you will hear a long beep with the green indicator turned on,
and the user ID will be displayed according to the specifi ed output format.
5. If the fi ngerprint is denied, you will hear a beep twice with the orage indicator blinking twice, and the fi ngerprint
error signal (Low Active) will be output for 500ms.
If the card is not registered
1. If you will hear a beep twice with the orange indicator blinking twice when presenting the card to the reader, this
indicates that the card is unregistered or already deleted.
2. For an unregistered card or denied fi ngerprint, the reader will output the fi ngerprint error signal (Low Active) for
500ms.
Englis_ English _ 23