Samsung OfficeServ 7100 Installation Manual page 29

OfficeServ 7100
TECHNICAL MANUAL
3.2.3 Installing MP10/MP10a
Install processor card (MP10/MP10a) in slot 0. The locations of slot 0 through slot 2 are
described in Figure 3.1.
1) Check the exterior of the MP10/MP10a card for any damage. If damage is found, do not
proceed with installation. Contact Samsung Technical Support.
Power the system OFF when installing or removing cards.
POWER TO THE CABINET MUST BE TURNED OFF. Failure to do so will
damage the card, cabinet and/or corrupt the data moving along the
data bus.
2) Align the MP10/MP10a card to the guardrail of slot 0 and carefully slide it in.
3) Press and lock the lever to fully insert into the slot.
Figure 3.5 Mounting the MP10/MP10a into Slot 0
Figure 3.6 Secure the MP10/MP10a into Slot 0
3.8
Home Page Table of Contents
INSTALLATION
PART 3 MAY 2010